IMPROVED
HPA Tippmann M4 TDC-Blok modification to steady Tipp-TDC-V3 incl. M3x5 inbus SW 1,5
Artikelnummer: D-00100HPA Tippmann M4 TDC-Blok modification to steady Tipp-TDC-V3 incl. M3x5 inbus SW 1,5
- For modification to steady and centralizing the (upgraded) hop-up unit (TDC-Nub = TippTDC-V3 NUB)
- How to assemble the TDC-block:
- You need to cut the tipp off the original screw and put this screw back to cover the hole;
- Place (assembling) the TDC-block into the front of the upper receiver;
- Screw the allen screw into the TDC-block. Not to deep. Only to hold it in;
- This wil hold the TippTDC-V3 NUB straight. And the BB's...
- Material 1 (Unit): Polyamide 12 (also PA 12 or nylon 12) or PET-G (polyethylene terephthalate glycol)
- Material 2 (Srew): RVS-A2 (AISI-304)
- Produced bij Brandon
It was manufactured to steady and centralizing the Tippmann M4 (Special made and Upgraded) TTR-TDC hop unit/nub. Which means you get an even better spin for better stability, more range and accuracy.
PET-G (polyethylene terephthalate glycol) is a very strong, water-resistant thermoplastic with a nice glossy finish.
Important features include a very good adhesion and do not break, but bend the material when pressure is applied.