BEGADI PRO 50° "MAG5" AEG R-Hop-Up bucking-packing-rubber (GREEN)

BEGADI PRO 50° "MAG5" AEG R-Hop-Up bucking-packing-rubber (GREEN) (Air Sealed, for approx, 5mm barrel window)

MAG5 - 50° Green  1,0 - 1,5 Joule with 0,28 bis 0,36g BBs

The MAG series are newly developed R-Hop buckings / rubbers from Begadi, designed in Germany! These are specially designed for modern AEG / S-AEG weapons and HopUp units and have some special features to increase the range and reduce the spread.
The patch of the MAG5 bucking has a radius of 2.9mm (5.8mm diameter). This is something like the BB itself and thus ensures that the BB is precisely centered in the barrel. The BB is also guided straight when fired in order to prevent outliers to the side. This patch is an R-Hop and is particularly good for heavy BBs.

All of the Begadi PRO buckings are made from a very robust and hard-wearing rubber mixture. This keeps the set HopUp effect constant for a long time and wears out much more slowly than conventional rubbers.
Even with dismantling or maintenance, you don't have to worry that the rubber will crack on the patch. Nevertheless, you should exercise some caution when pulling it off. Please pay attention to the correct selection of the hardness for your weapon (energy and bullet weight). If a rubber that is too soft is chosen, the wear increases!

Alignment: To prevent the bucking from twisting on the barrel, the patch lies directly on the left and right of the barrel window.
The transition between nozzle and bucking (sealing lip) is rounded. This rounding makes it possible for the nozzle to load the BB more easily into the HopUp. This also creates a very good seal to the nozzle (correct nozzle length required)
Two elevations in the front area: At these points our rubbers / buckings have a diameter of 9.80mm, which press into the HopUp unit during installation and thus no pressure is lost.

Marking / hardening: In order to be able to tell our buckings apart, the respective version is marked directly. The rubber compound (hardness) is reflected in the color: 50 ° green - 60 ° blue - 70 ° black. This means that you can immediately see which version it is.

Versions 5mm or 7mm: Another special feature are the two available lengths of the inner patch. The respective number indicates the required length of the scrolling window.

• 5mm version: These buckings are compatible with all standard barrels with a HopUp window of 4.8 - 5.2mm. For particularly heavy BBs (0.40g +) we recommend using the 7mm version + tuning barrel, as less pressure of the tensioner is required here.
• 7mm version: This is a special version which is only suitable for tuning runs with a 6.8 - 7mm window. (DaVinci 70, TNT ...). The significantly longer patch creates a significantly stronger Magnus effect and is particularly suitable for heavy BBs. Please note that light BBs are more likely to overhop! We recommend using the 7mm combination only from 0.40g + BBs.

The M14 from Cyma uses a much shorter bucking. The MAG5 or MAG7 can be used here, but the rubber must be cut off at the front (towards the mouth) by 2 - 3mm.

Hop-Up / HopUp / Hop Up